Hardware Reference Guide

11. To install an M.2 SSD card, slide the pins on the card into the system board connector while holding the
card at approximately a 30° angle (1). Press the other end of the card down (2), and then secure the card
with the screw (3).
12. Hold the drive cage at an angle so that the tabs and slots on the side of the drive cage and chassis are
aligned, and then slide the tabs and slots together (1). Then press the other side of the drive cage down
(2) so that the release lever locks the drive cage in place.
13. Connect the power and data cables to the rear of the drives in the drive cage.
14. Replace the front bezel.
15. Replace the computer access panel.
16. If the computer was on a stand, replace the stand.
17. Reconnect the power cord and any external devices, and then turn on the computer.
18. Lock any security devices that you disengaged when you removed the access panel.
32 Chapter 2 Hardware upgrades