Maintenance and Service Guide

Drive cage
You must remove the drive cage to access the components underneath.
1. Prepare the computer for disassembly (Preparation for disassembly on page 17).
2. Remove the access panel (Access panel on page 18).
3. Remove the front bezel (Front bezel on page 19).
4. Disconnect the power and data cables from the rear of the drives in the drive cage.
5. Press the release lever on the side of the drive cage (1), and then lift that side of the drive cage up (2).
6. Remove the drive cage from the chassis (3).
To install the drive cage, reverse the removal procedure.
22 Chapter 4 Removal and replacement procedures