Maintenance and Service Guide

Installing a 9.5 mm slim optical drive
1. Prepare the computer for disassembly (Preparation for disassembly on page 17).
2. Remove the access panel (Access panel on page 18).
3. If you are installing a slim optical drive in a bay covered by a bezel blank, remove the front bezel (Front
bezel on page 19) and then remove the bezel blank (Slim optical drive bezel blank on page 20).
4. Align the small pin on the release latch with the small hole on the side of the drive and press the latch
rmly onto the drive.
5. Slide the optical drive through the front bezel all the way into the bay (1) so that the latch on the rear of
the drive locks into place (2).
Drives 33