Maintenance and Service Guide

Card reader
The card reader is attached to the front of the computer.
1. Prepare the computer for disassembly (Preparation for disassembly on page 17).
2. Remove the access panel (Access panel on page 18).
3. Remove the front bezel (Front bezel on page 19).
4. Remove the drive cage (Drive cage on page 22).
5. From the inside of the chassis, disconnect the card reader cable from the white system board labeled SD
RDR.
6. Remove the screw that secures the card reader to the front of the computer (1), and then remove the
card reader from the computer (2).
To install the card reader, reverse the removal procedures.
48 Chapter 4 Removal and replacement procedures