Maintenance and Service Guide

Speaker
The speaker is attached to the front of the rotating drive cage.
1. Prepare the computer for disassembly (Preparation for disassembly on page 17).
2. Remove the access panel (Access panel on page 18).
3. Remove the front bezel (Front bezel on page 19).
4. Remove the drive cage (Drive cage on page 22).
5. From the outside, front of the chassis, remove the two Phillips screws that secure the speaker.
6. From the inside of the chassis, disconnect the speaker cable from the white system board labeled SPKR
(1), remove the cable from the clips in the front I/O bracket (2), and then remove the speaker from the
front of the chassis (3).
To install the speaker, reverse the removal procedures.
Speaker 49