Maintenance and Service Guide

5. Disconnect the battery cable from the system board (see Battery on page 14).
6. Remove the speaker (see Speaker on page 17).
Remove the system board: [callout 5 IDing button board cable ZIF connector on system board]
1. Disconnect the following cables from the system board:
(1) Connector board cable (see Connector board on page 21)
(2) Microphone cables (must be unsoldered, see Microphone on page 20)
(3) TouchScreen cable ZIF connector on system board
(4) XRay cable ZIF connector on system board
(5) Power/volume button board cable ZIF connector on system board
2. Remove the three Phillips PM1.4×3.6 screws (1) that secure the system board to the display
panel assembly.
3. Remove the three Phillips PM1.4×2.2 broad head screws (2) that secure the audio jack light pipe
and system board to the display panel assembly.
4. Remove the audio jack light pipe (3).
The audio jack light pipe is included with the ???.
System board 23