User guide
Troubleshooting
C4705-90000
8-45
'+('&) & * !) *)* !) *& " ! * /%$! (!*!&% &% * 1.!) !) !% * &((*
(%
1.!) (!*!&% *)* '(&($) * ) *-& *)*)
D ! *)*
D (!*!&% *)*
(&($ * 1.!) (!*!&% *)* ) &##&-)
% * (,! )*) )+$%+ )(&## *& 0 1.!) (!*!&% % '())
SERVICE TESTS
24 Y-axis friction
0! )* (!*!&% )* $)) !) !)'#/ &% * (&%*1'%#
()) * *& '(&($ * #! *)*
If you want to perform the friction test, then go to step .
0 $&,)*&' $)) !) !)'#/ &% * (&%*1'%# ()) *
+**&% *& )*&' * *)*
Check that the carriage moves along the YĆaxis without binding.
/&+ -%* *& '(&($ * (!*!&% *)* * % * )*' '()) *
0& +* ) ()) %*( $)) !) !)'#/ &% * (&%*1'%#
())
If the average value (###) of is less than 100 then the test has passed.
If the average value (###) of is more than 100 then the test has failed.
If the test fails, try one of the following:
1 Clean the slider rod.
2 Replace the YĆaxis motor ' page 6Ć24.
3 Perform the YĆaxis encoder test ' page 8Ć47.
4 Replace the carriage ' page 6Ć34.
0 +*()) %*( $)) !) !)'#/ &% * (&%*1'%#
This value (#) is for the cutter PWM and is for reference purposes only.