User guide

              
            
   
        

: Make sure you connect all cables in the correct orientation and in the correct
sockets.
       
     
: Temporarily leave the screws
loose; tighten the serial and parallel connector
screws first; then tighten the PCA screws.
        
Front-panel PCA
X-Encoder
(Media encoder)
Hung LE (P1)
Hung LE (P2)
Pinch-wheel
sensor
Media sensor
Primer sensor
Drop detector
Wiper stepper
Y – Carriage
motor
X – Media motor
Bail stepper
P18
Primer stepper
Bitronics
RS-232-C
SIMM’s
connectors
RAM
RAM
POST
CODE
M-10
Power supply
Tx 10
 After installing a new
main PCA, if the EEROM data has not
been saved and loaded (see 6Ć9 note),
then the following calibrations must be
performed in the order listed:
1. DropĆdetector calibration  page 7Ć4.
2. LineĆsensor calibration  page 7Ć5.
3. Accuracy calibration  page 7Ć6.
6-10 Removal and Replacement
C4705-90000