User guide

 After reassembling the plotter, perform:
D Accuracy calibration '  
D DropĆdetect calibration ' page 7Ć4.

1 Install the two upper screws
leaving them loose.
2 Press down on the sloping
plastic and tighten the left
upper screw as shown. Prevent
any slackness or motion of the
service station while it is being
screwed in place. This is very
important.
3 Tighten the right upper screw.
4 Install the bottom screw.
     
    


6-43
Removal and ReplacementC4705-90000