Maintenance and Service Guide

Table 8-40 Issues, possible causes, and xes (continued)
Items Procedures
The sections below are intended for authorized service providers/technicians.
1. Verify that the wireless module and its antenna cables are fully inserted
and in good condition (see WLAN module removal and replacement
section). Reseat wireless module and antenna connection.
2. Verify module antenna cable connection are not loose.
3. Verify antenna cables are properly connected to the MAIN and AUX
terminals (see WLAN module removal and replacement section).
WWAN
Table 8-41 Issues, possible causes, and xes
Items Procedures
Symptom
Unable to nd networks/service
Possible causes
Network source, cable, connection, driver, settings.
Troubleshooting steps
1. Update to the latest driver and utility.
2. Check with network service provider for signal coverage.
3. Make sure signal strength is good.
4. Make sure your service is active.
The sections below are intended for authorized service providers/technicians.
● Verify module and antenna cable connections are not loose.
● Verify antenna cables are properly connected to the correct terminals. For example, the
antenna cable labeled “1” connects to the “Main” terminal labeled “1”. The antenna cable
labeled “2” connects to the “Aux” terminal labeled “2”.
USB
Table
8-42 Issues, possible causes, and xes
Items Procedures
Symptoms
● USB devices are not recognized
● USB devices are not charging
Possible causes
USB devices do not have the latest software drivers, port insucient power, or not
compliant.
NOTE: USB Type-C uses a dierent connector entirely
Examples of USB device Not Recognized Troubleshooting steps
1. Unplug USB device and/or restart the computer (wait for 2-5 minutes) to reset USB
port/hub in case of power surge.
124 Chapter 8 Troubleshooting guide