Maintenance and Service Guide

Solid-state drive (SSD)
Table 5-2 Solid-state drive descriptions and part numbers
Description Spare part number
2 TB, PCIe, TLC L62766-001
1 TB, PCIe, TLC L62763-001
512 GB, PCIe, TLC L62769-001
512 GB, PCIe, Self-encrypting drive (SED), Opal 2, TLC L62768-001
512 GB, SATA-3, FIPS-140-2, TLC L62767-001
256 GB, PCIe, NVMe, TLC L64700-001
256 GB, PCIe, NVMe, value L62765-001
256 GB, SATA-3, Opal 2, TLC L64701-001
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 34).
2. Remove the bottom cover (see Bottom cover on page 34).
3. Disconnect the battery cable from the system board (see Battery on page 46).
Remove the solid-state drive:
1. Remove the Phillips M2.0 × 2.0 screw (1) that secures the drive to the system board.
2. Remove the drive by pulling it away from the connector (2).
NOTE: M.2 solid-state drives are designed with notches to prevent incorrect insertion.
Reverse this procedure to install the solid-state drive.
36 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts