Maintenance and Service Guide

Smart card reader
Table 6-10 Smart card reader, insert, and cable descriptions and part numbers
Description Spare part number
Smart card reader L60626-001
Smart card insert L60627-001
Smart card reader cable (available in Cable Kit) L60602-001 (Cable Kit)
L72085-001 (Cable Kit,
privacy)
Before removing the card reader, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 32).
2. Remove the bottom cover (see Bottom cover on page 32).
3. Remove the battery (see Battery on page 45).
Remove the smart card reader:
NOTE: Before you remove the smart card reader, make sure nothing (memory card or plastic insert) in
inserted in the reader.
1. Disconnect the system board cable from the connector on the smart card reader board (1).
2. Disconnect the touchpad cable from the ZIF connector on the smart card reader board (2).
3. Remove the three Phillips M2.0 × 2.0 screws (3) that secure the smart card reader to the computer.
4. Remove the smart card reader from the computer (4).
Reverse this procedure to install the smart card reader.
56 Chapter 6 Removal and replacement procedures for authorized service provider parts