Maintenance and Service Guide

Display assembly
Before removing the display assembly, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 32).
2. Remove the bottom cover (see Bottom cover on page 32).
3. Disconnect the battery cable from the system board (see Battery on page 45).
Remove the display assembly:
1. Disconnect the antenna cables from the WWAN module (1) and the WLAN module (2).
2. Disconnect the display cable (3) and the camera cable (3) from the system board.
3. Remove the cables from the clips built into the computer (4).
4. With the computer upside down, open the display, and then place the computer on a table with the
display positioned o the edge of the table (1).
5. Remove the ve Phillips M2.5 × 4.0 screws (2) from the display hinges.
Component replacement procedures 65