Maintenance and Service Guide
Table Of Contents
- Product description
- Components
- Illustrated parts catalog
- Removal and replacement procedures preliminary requirements
- Removal and replacement procedures for Customer Self-Repair parts
- Removal and replacement procedures for authorized service provider parts
- Interpreting system validation diagnostic front panel LEDs and audible codes
- Troubleshooting guide
- Resources
- General troubleshooting steps
- Identify the issue
- Analyze the issue
- Resolve the issue
- Verify solution
- Helpful Hints
- Common issues and possible solutions
- Additional information
- Acronyms
- Blinking lights and boot error codes
- Processor not executing code
- BIOS recovery code unable to find valid BIOS recovery image
- Memory module error
- Graphics Controller Error (No Controller)
- Failure - System Board Error
- Intel Trusted Execution Technology (TXT) Error
- Sure Start unable to find valid BIOS Boot Block image
- Sure Start has identified a problem (Manual Recovery Policy Set)
- POST error messages and user actions
- Routine maintenance for performance improvement
- Common blue screen error messages
- Use Windows Debugging Tool
- Display issue: pixel anomalies
- Cable management
- Connector types
- Computer Setup (BIOS), TPM, and HP Sure Start
- Using HP PC Hardware Diagnostics
- Backing up, restoring, and recovering
- Specifications
- Power cord set requirements
- Statement of memory volatility
- Recycling
- Index
Table 2-6 Buttons, speakers, and ngerprint reader and their descriptions (continued)
Component Description
● When the computer is in Hibernation, press the button
briey to exit Hibernation.
IMPORTANT: Pressing and holding down the power button
results in the loss of unsaved information.
If the computer has stopped responding and shutdown
procedures are ineective, press and hold the power button for at
least 5 seconds to turn o the computer.
To learn more about your power settings, see your power
options.
▲ Right-click the Power meter icon and then select
Power Options.
(2) Vents (2) Enable airow to cool internal components.
NOTE: The computer fan starts up automatically to cool
internal components and prevent overheating. It is normal for the
internal fan to cycle on and o during routine operation.
(3) Speakers (2) Produce sound.
(4) Fingerprint reader (select products only) Allows a ngerprint logon to Windows, instead of a password
logon.
▲ Swipe down across the ngerprint reader.
IMPORTANT: To prevent ngerprint logon issues, make
sure when you register your ngerprint that all sides of your
nger are registered by the ngerprint reader.
14 Chapter 2 Components