Maintenance and Service Guide
Table Of Contents
- Product description
- Components
- Illustrated parts catalog
- Removal and replacement procedures preliminary requirements
- Removal and replacement procedures for Customer Self-Repair parts
- Removal and replacement procedures for authorized service provider parts
- Interpreting system validation diagnostic front panel LEDs and audible codes
- Troubleshooting guide
- Resources
- General troubleshooting steps
- Identify the issue
- Analyze the issue
- Resolve the issue
- Verify solution
- Helpful Hints
- Common issues and possible solutions
- Additional information
- Acronyms
- Blinking lights and boot error codes
- Processor not executing code
- BIOS recovery code unable to find valid BIOS recovery image
- Memory module error
- Graphics Controller Error (No Controller)
- Failure - System Board Error
- Intel Trusted Execution Technology (TXT) Error
- Sure Start unable to find valid BIOS Boot Block image
- Sure Start has identified a problem (Manual Recovery Policy Set)
- POST error messages and user actions
- Routine maintenance for performance improvement
- Common blue screen error messages
- Use Windows Debugging Tool
- Display issue: pixel anomalies
- Cable management
- Connector types
- Computer Setup (BIOS), TPM, and HP Sure Start
- Using HP PC Hardware Diagnostics
- Backing up, restoring, and recovering
- Specifications
- Power cord set requirements
- Statement of memory volatility
- Recycling
- Index
4 Removal and replacement procedures
preliminary requirements
Tools required
You will need the following tools to complete the removal and replacement procedures:
● Non-conductive, non-marking pry tool
● Magnetic Phillips P1 screwdriver
● Torx T8 screwdriver
Service considerations
The following sections include some of the considerations that you must keep in mind during disassembly
and assembly procedures.
NOTE: As you remove each subassembly from the computer, place the subassembly (and all accompanying
screws) away from the work area to prevent damage.
Plastic parts
IMPORTANT: Using excessive force during disassembly and reassembly can damage plastic parts.
Cables and connectors
IMPORTANT: When servicing the computer, be sure that cables are placed in their proper locations during
the reassembly process. Improper cable placement can damage the computer.
Cables must be handled with extreme care to avoid damage. Apply only the tension required to unseat or seat
the cables during removal and insertion. Handle cables by the connector whenever possible. In all cases, avoid
bending, twisting, or tearing cables. Be sure that cables are routed in such a way that they cannot be caught
or snagged by parts being removed or replaced. Handle ex cables with extreme care; these cables tear
easily.
Tools required 27