Hardware Reference Guide

8. To install an M.2 SSD card, slide the pins on the card into the system board connector while holding the
card at approximately a 30° angle (1). Press the other end of the card toward the chassis (2), secure the
card with the screw (3), replace the bracket (4), and then replace the grill (5).
9. Replace the drive cage. Slide the tabs on the right side of the drive cage into the slots on the chassis (1),
and then press the left side of the drive cage down onto the chassis (2).
10. Reconnect the power and data cables to all drives in the drive cage.
11. Replace the front bezel.
12. Replace the computer access panel.
13. If the computer was on a stand, replace the stand.
Removing and installing drives 33