Owner manual

HP 8/20q Fibre Channel Switch QuickTools Switch Management User Guide 37
You cannot edit an active zone set on a switch. You must configure an inactive zone set to your needs and
then activate that updated zone set to apply the changes to the fabric. When you activate a zone set, the
switch distributes that zone set to the temporary zoning database on every switch in the fabric. However, in
addition to the merged active zone set, each switch maintains its own original zone set in its zoning
database. However, only one zone set can be active at one time.
NOTE: If the Merge Auto Save parameter is enabled on the Zoning Configuration dialog box, then
every time the active zone set changes, the switch copies it into an inactive zone set stored on the switch.
To conveniently apply the changes to the active zone set, you can edit the copy of the active zone set, and
then activate the updated copy. The edited copy then becomes the active zone set.
The Edit Zoning dialog box has a Zone Sets tree on the left and a Port/Device (or members) tree on the
right. Both trees use display conventions similar to those used by the fabric tree for expanding and
contracting zone sets, zones, and ports. An expanded port shows the port Fibre Channel address; an
expanded address shows the port WWN. You can select zone sets, zones, and ports in any one of the
following ways:
• Click a zone, zone set, or port icon.
• Right-click to select a zone set or zone, and then open the corresponding popup menu.
• Press and hold down the Shift key while clicking several consecutive icons.
• Press and hold down the Control key while clicking several non-consecutive icons.
Using the tool bar buttons, popup menus, or the drag-and-drop method, you can create and manage zone
sets and zones in the zoning database. Table 6 describes the zoning tool bar operations.
To create and manage zone sets:
1. Use the Edit Zoning dialog box to define zoning changes, and then click Apply to open the Error Check
dialog box.
2. Click Error Check to have QuickTools check for zoning conflicts, such as empty zones, aliases, or zone
sets, and zones with non-domain ID/port number membership.
3. Click Save Zoning to implement the changes.
4. Click Close to close the Error Check dialog box.