Owner manual

50
NTP Client Enabled Allows switches to synchronize their time to a centralized server.
Enabled or Disabled.
NTP Server Address The IP address of the centralized NTP server. Ethernet connection to
NTP server is required.
FDMI Enable Fabric Device Management Interface status. If enabled, device
information can be obtained, managed, and saved through the fabric
using Name Service Management Server functions. If FDMI is
Enabled on the entry switch, QuickTools reports all FDMI information
reported by the entry switch.
FDMI HBA Entry Limit Maximum number of HBAs that can be registered with a switch.
Embedded GUI Enabled QuickTools web applet status. Indicates whether the web applet on
the switch is Enabled or Disabled.
Inactivity Timeout Number of minutes the switch waits before terminating an idle
command line interface (CLI) session. Zero (0) disables the timeout
threshold.
GUI Mgmt Enabled Management application status. If Disabled, the switch cannot be
managed using QuickTools or Enterprise Fabric Management Suite.
Telnet Enabled Telnet client status Enabled or Disabled.
SSH Enabled Secure Shell status. If Enabled, an encrypted data path is provided
for command line interface sessions.
SSL Enabled Secure Sockets Layer status. If enabled, encryption for the QuickTools
web applet, Enterprise Fabric Management Suite, and CIM sessions
is provided.
CIM Enabled Common Interface Model status. The CIM agent is based on the
Storage Networking Industry Association (SNIA) Storage
Management Initiative Specification (SMI-S), which is the standard for
SAN management in a heterogeneous environment.
FTP Enabled FTP status Enabled or Disabled.
Management Server Enabled Management server status Enabled or Disabled.
SNMP Enabled SNMP status, Enabled or Disabled.
Call Home Enabled Call Home status. If enabled and configured, switches can send alerts
to pagers and e-mail. Users can configure the type of events and
where the alerts are sent.
Zones/Security Group
Interop Mode Standard
Legacy Address Format None
Merge Auto Save If Enabled, any zoning updates from the fabric are saved in
permanent (non-volatile) memory as well as temporary memory. If
Disabled, any zoning updates from the fabric are saved only in
temporary memory and are lost after a switch reset.
Default Zone Enables or disables communication between ports and devices not
defined in the active zone set, or when there is no active zone set.
Discard Inactive Automatically removes the previously active zone set when a zone set
is activated on a switch.
Table 8 Switch data window fields (Continued)
Field Description