Maintenance and Service Guide
Table Of Contents
- Computer features
- Illustrated parts catalog
- Routine care, SATA drive guidelines, and disassembly preparation
- Removal and replacement procedures
- Computer Setup (F10) Utility
- Troubleshooting without diagnostics
- Safety and comfort
- Before you call for technical support
- Helpful hints
- Solving general problems
- Solving power problems
- Solving hard drive problems
- Solving media card reader problems
- Solving display problems
- Solving audio problems
- Solving printer problems
- Solving keyboard and mouse problems
- Solving hardware installation problems
- Solving network problems
- Solving memory problems
- Solving CD-ROM and DVD problems
- Solving USB flash drive problems
- Solving front panel component problems
- Solving Internet access problems
- Solving software problems
- POST error messages
- Password security and resetting CMOS
- Using HP PC Hardware Diagnostics
- Backing up, restoring, and recovering
- Power cord set requirements
- Statement of memory volatility
- Specifications
- Index
Card reader
The card reader is attached to the front of the computer.
Before removing the card reader, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 20).
2. Remove the access panel (Access panel on page 23).
3. Remove the front bezel (Front bezel on page 24).
4. Remove the drive cage (Drive cage on page 26).
Remove the card reader:
1. Remove the screw that secures the card reader to the front of the computer (1).
2. From the inside of the chassis, disconnect the card reader cable from the system board connector
labeled SD RDR (2).
3. Remove the card reader from the computer (3).
To install the card reader, reverse the removal procedures.
Card reader 53