Maintenance and Service Guide
Table Of Contents
- Computer features
- Illustrated parts catalog
- Routine care, SATA drive guidelines, and disassembly preparation
- Removal and replacement procedures
- Computer Setup (F10) Utility
- Troubleshooting without diagnostics
- Safety and comfort
- Before you call for technical support
- Helpful hints
- Solving general problems
- Solving power problems
- Solving hard drive problems
- Solving media card reader problems
- Solving display problems
- Solving audio problems
- Solving printer problems
- Solving keyboard and mouse problems
- Solving hardware installation problems
- Solving network problems
- Solving memory problems
- Solving CD-ROM and DVD problems
- Solving USB flash drive problems
- Solving front panel component problems
- Solving Internet access problems
- Solving software problems
- POST error messages
- Password security and resetting CMOS
- Using HP PC Hardware Diagnostics
- Backing up, restoring, and recovering
- Power cord set requirements
- Statement of memory volatility
- Specifications
- Index
Speaker
The speaker is attached to the inside-front of the computer.
Before removing the speaker, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 20).
2. Remove the access panel (Access panel on page 23).
3. Remove the front bezel (Front bezel on page 24).
4. Remove the drive cage (Drive cage on page 26).
Remove the speaker:
1. Remove the two Phillips screws (1) that secure the speaker to the front of the chassis.
2. Disconnect the speaker cable from the system board connector labeled SPKR (2), remove the cable from
the clip (3), and then remove the speaker from the computer (4).
To install the speaker, reverse the removal procedures.
54 Chapter 4 Removal and replacement procedures