Maintenance and Service Guide

Drives

For a list of available drives, see Drives on page 6.

Drive positions

1 3.5-inch hard drive bay

2 9.5 mm slim optical drive bay

NOTE: The drive conguration on your computer may be dierent than the drive

conguration shown above.

Installing and removing drives

When installing drives, follow these guidelines:

●

The primary Serial ATA (SATA) hard drive must be connected to the dark-blue primary SATA connector on

the system board labeled SATA0.

●

Connect an optical drive to one of the light-blue SATA connectors on the system board (labeled SATA1

and SATA2).

IMPORTANT: To prevent loss of work and damage to the computer or drive:

If you are inserting or removing a drive, shut down the operating system properly, turn o the computer, and

unplug the power cord. Do not remove a drive while the computer is on or in standby mode.

Before handling a drive, be sure that you are discharged of static electricity. While handling a drive, avoid

touching the connector. For more information about preventing electrostatic damage, refer to Electrostatic

discharge information on page 9.

Handle a drive carefully; do not drop it.

Do not use excessive force when inserting a drive.

Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic elds such as

monitors or speakers.

If a drive must be mailed, place the drive in a bubble-pack mailer or other protective packaging and label the

package “Fragile: Handle With Care.”

Drives 31