Maintenance and Service Guide

Solid-state drive (SSD)
Table 5-2 Solid-state drive descriptions and part numbers
Description Spare part number
2 TB, PCIe, TLC L60650-001
1 TB, PCIe, TLC L60649-001
512 GB, PCIe, TLC L60646-001
512 GB, PCIe, self-encrypting drive (SED), Opal 2, TLC L60644-001
512 GB, SATA-3, FIPS-140-2, TLC L60645-001
512 GB, PCIe, value L60647-001
512 GB, PCIe + 32 GB Optane Memory L60648-001
256 GB, PCIe, NVMe, TLC L60642-001
256 GB, PCIe, NVMe, value L60643-001
256 GB, SATA-3, self-encrypting drive (SED), Opal 2, TLC L60641-001
128 GB, SATA-3, TLC L60640-001
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 32).
2. Remove the bottom cover (see Bottom cover on page 32).
3. Disconnect the battery cable from the system board (see Battery on page 45).
Remove the solid-state drive:
1. Remove the Phillips M2.0 × 2.0 screw (1) that secures the drive to the system board.
2. Remove the drive by pulling it away from the connector (2).
NOTE: M.2 solid-state drives are designed with notches to prevent incorrect insertion.
Reverse this procedure to install the solid-state drive.
34 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts