System information

Chapter 1
Overview and Common Procedures—Server Upgrade
Removing and Replacing the System Covers
19
b. Close the cover until it snaps onto the system chassis.
Figure 1-6 Replacing the Plastic Side Cover
Rack-Mount System
To access the internal components on a rack-mounted system, pull the system out onto the rail guides and
remove the top cover.
Accessing a Rack Mounted Server
The HP 9000 rp3410 and HP 9000 rp3440 servers are designed to be rack mounted. The following procedure
explains how to gain access to a server that is mounted in an approved rack. For slide installation
instructions, refer to the Installation Guide, Mid-Weight Slide Kit, 5065-7291.
WARNING Ensure that all anti-tip features (front and rear anti-tip feet installed; adequate
ballast properly placed, etc.) are employed prior to extending the server.
Extend the Server from the Rack
NOTE Ensure that there is enough area (approximately 1.5 meters [4.5 ft.]) to fully extend the server
out the front to work on it.
To extend the server from the rack, perform the following steps: