System information

HP 9000 rp3410 1-way Server to HP 9000 rp3410 2-way Server Upgrade Procedure
Processor Upgrade Procedure
Chapter 3
63
BOot [PRI|ALT|<path>] Boot from specified path
DIsplay Redisplay the current menu
HElp [<command>] Display help for specified command
RESET Restart the system
MAin Return to Main Menu
Service Menu: Enter command or menu >
Step 5. Enter upgrade. The server responds with a message indicating that this command performs an
rp3410 1-way to rp3410 2-way model upgrade and that the server must be reset following the
operation. Enter Y (yes) to continue. The server prompts you to enter the key number. Enter the
key number that you copied onto the system upgrade label. Take upper and lower case sensitivity
into account when entering the key number. Example:
Service Menu: Enter command > upgrade
System serial number: USS3915004
Enter key from key certificate for this serial number: 3B567636ACDD
Current system: 9000/800/rp3410 1 socket 1 core restricted speed DC- -
Upgraded system: 9000/800/rp3410 1 sockets 2 cores
Do you wish to continue with this change? [y/n]: Y
You must restart the system to complete this change.
NOTE The upgrade command is a hidden command. It will not appear in response to the ls
(list commands) command in the firmware menus.
If the key number is accepted, the server displays a message indicating the upgrade was successful
and that the system must be reset for the change to take place. If the key is not accepted, the
server displays a message indicating the key is invalid. Retry the upgrade command and re-enter
the key value. Check for case sensitivity. If still unsuccessful, contact your HP representative.
Step 6. Enter the command rs to reset the server. If AUTOBOOT is enabled, the server displays a
message: Autoboot enabled, Hit any key within 10 seconds to interrupt the boot
process. Interrupt the boot process. Example:
CM> rs
NOTE This step must be done for the upgrade to take effect.
Step 7. Verify the upgrade. In the BCH Main Menu, enter: in pr