System information

HP 9000 rp3440 1-Way Server to HP 9000 rp3440 2-Way Server Upgrade Procedure

Processor Upgrade Procedure

Chapter 4

BOot [PRI|ALT|<path>] Boot from specified path

DIsplay Redisplay the current menu

HElp [<command>] Display help for specified command

RESET Restart the system

MAin Return to Main Menu

Service Menu: Enter command or menu >

Step 5. Enter upgrade. The server responds with a message indicating that this command performs an

rp3440 1-way to rp3440 2-way upgrade and that the server must be reset following the operation.

Enter Y (yes) to continue. The server prompts you to enter the key. Enter the key value that you

copied onto the system label. Take upper and lower case sensitivity into account when entering the

key number. Example:

NOTE This example is taken from an 800 MHz system. In 1 GHz systems, processor speed

is shown as 1000 MHz.

Service Menu: Enter command > upgrade

System serial number: USS3915004

Enter key from key certificate for this serial number: 3B567636ACDD

Current system: 9000/800/rp3440 1 socket 1 core restricted speed DC- -

Upgraded system: 9000/800/rp3440 1 sockets 2 cores

Do you wish to continue with this change? [y/n]: Y

You must restart the system to complete this change.

NOTE The upgrade command is a hidden command. It does not appear in response to the

ls (list commands) command in the firmware menus.

If the key number is accepted, the server displays a message indicating the upgrade was successful

and that the system must be reset for the change to take place. If the key number was not

accepted, the server displays a message indicating the key was invalid. Retry the upgrade

command and re-enter the key value. Check for case sensitivity. If still unsuccessful, contact your

HP representative.

Step 6. Enter the command rs to reset the server. If AUTOBOOT is enabled, the server displays a

message: Autoboot enabled, Hit any key within 10 seconds to interrupt the boot

process. Interrupt the boot process. Example:

CM> rs