System information

HP 9000 rp3410 Server to HP 9000 rp3440 Server Processor Upgrade Procedure

Processor Upgrade Procedure

Chapter 5

Step 8. Verify the upgrade. If AUTOBOOT is enabled, the server displays a message: Autoboot enabled,

Hit any key within 10 seconds to interrupt the boot process. Interrupt the boot process.

Example:

CM> rs

Step 9. Verify the upgrade. In the BCH Main Menu, enter: in pr

Examine the model string value. It should be 9000/800/rp3440

Example:

NOTE Processors 2 and 3 are listed in this example because a dual processor module is

installed in CPU socket 1.

Main Menu: Enter command or menu > in pr

Model: hp server . (model string 9000/800/rp3440)

PROCESSOR INFORMATION

HVERSION SVERSION Processor

Processor Speed Model Model/Op CVERSION State

--------- -------- -------- -------- -------- -------------

0 800 MHz 0x0889 0x0491 3.0 Active

1 800 MHz 0x0889 0x0491 3.0 Idle

2 800 MHz 0x0889 0x0491 3.0 Idle

3 800 MHz 0x0889 0x0491 3.0 Idle

Central Bus Speed (in MHz) : 200

Software ID (dec) : 4471560586272672004

Software ID (hex) : 0x3e0e2ca9706b8904

Software Capability : 0x01f0

Step 10. Apply the label containing the system serial number to the reverse side of the pull tab.

Step 11. On the front bezel, replace the HP 9000 rp3410 server nameplate with the HP 9000 rp3440 server

nameplate.

Step 12. Boot the operating system.