System information

RAID - Smart Array 6402 or 6404 Controller for Internal RAID Installation
Smart Array 6402 RAID or 6404 RAID Cards
Chapter 6
90
• Cable A7231-63024 is used for the single channel or simplex RAID card
• Cable A7231-63025 is used for the dual channel or duplex RAID card
Before installing the RAID card, refer to the Internal Cabling Guide for HP Smart Array Controllers HP P/N
5971-4280 available at http://www.docs.hp.com.
PCI Slots
Before inserting a RAID card, be certain of which PCI slot are available for RAID and if the slot can be used
for internal or external RAID. Internal RAID is not supported on rp3410 systems.
NOTE Internal RAID is not supported on rp3410 systems.
The following table lists the PCI slots and information about the RAID card that can be inserted into each
slot.
IMPORTANT Do not use both the internal and external connectors on one port simultaneously. The card will
not function if both connectors on one port are used.
Installing RAID for Simplex Configuration
The RAID card comes pre-configured. You do not have to set any jumpers or connectors.
WARNING Ensure that the system is powered down and all power sources have been
disconnected from the server prior to working with the server.
Voltages are present at various locations within the server whenever an AC power
source is connected. This voltage is present even when the main power switch is in
the off position.
Failure to observe this warning could result in personal injury or damage to
equipment.
Step 1. Back up data before installing the RAID card.
Step 2. Shut down the system.
Step 3. Power off the system, and unplug the power cord.
Table 6-1 PCI Slots
PCI
Slot #
Description
1 Cannot be used with internal or external RAID.
2 Used only for external RAID 6402 or 6404. Use this slot for rp3410.
3 Only slot that can be used for internal RAID 6402 or 6404. Can be
used for external RAID also. Use this slot for rp3440.
4 Cannot be used with internal or external RAID.