System information

RAID - Smart Array 6402 or 6404 Controller for Internal RAID Installation

Smart Array 6402 RAID or 6404 RAID Cards

Chapter 6

Step 4. Remove the PCI card cage. Refer to “Removing and Replacing the PCI Card Cage” in the HP 9000

rp3410 and HP 9000 rp3440 Maintenance Guide.

Step 5. Disconnect the SCSI cable(s) from the internal SCSI backplane.

Step 6. Install the Install the Smart Array 6402 or 6404 card.

Figure 6-1 Smart Array 6402 RAID Card

The following table lists the RAID card components.

Step 7. Slide the RAID card edge-connector into the slot until it is fully seated.

Step 8. Route the new SCSI cable(s) from the internal disks to the Smart Array card and connect the

cables.

Table 6-2 RAID Card Components

Item

Description

1 Internal SCSI connector, port A1

2 Internal SCSI connector, port A2

3 External SCSI connector, port A1

4 External SCSI connector, port A2

5 Controller battery

6 Battery-backed cache module

7 Connector for expansion board