HP Business Notebook Intel® vProTM setup and configuration 2011 Business Notebook Models - Technical white paper

will be deleted and the default hash will be made active. It does not reset all ME

Configuration settings or passwords.

Partial unprovisioning is available for Enterprise mode provisioned systems. Partial

unprovisioning will return all AMT Configuration setting to factory defaults with the

exception of the PID, PPS, and PKI-CH. It does not reset ME Configuration settings or

passwords.

b. Un-provisioning message will appear. This usually takes about one minute.

c. After unprovisioning is done, control is passed back to the AMT Configuration

screen.

Notice that the Setup and Configuration option is available again since the system is set to the

default Enterprise mode.

2. Return to previous menu.

3. Exit.

a. Select Y.

4. System will reboot.

A partial unprovisioning will re-open the network interface for six hours of Hello message

broadcasts.

Full Return to Factory Defaults

All MEBx settings can be returned to the factory default by clearing CMOS. This includes resetting

the password to the default “admin”. The system will need to be set up and configured again

before remote management is possible. Any non-default certificate hashes will have to be re-

applied.

Intel AMT WebGUI

The Intel AMT WebGUI is a web browser based interface for limited remote system management. The

WebGUI is often used as a test to determine if AMT setup and configuration was performed properly

on a system. A successful remote connection between a remote system and the host system running

the WebGUI indicates proper AMT setup and configuration on the remote system. The AMT WebGUI

is accessible from the following web browsers:

 Microsoft Internet Explorer 6 SP1 or newer

 Netscape Navigator 7.1 or newer

 Mozilla Firefox 1.0 or newer

 Mozilla 1.7 or newer

Limited remote system management includes:

 Hardware inventory

 Event logging

 Remote system reset

 Changing of network settings

 Addition of new users and passwords

 Updating ME firmware

WebGUI support is enabled by default for SMB setup and configured systems. WebGUI support

for enterprise setup and configured systems is determined by the Setup and Configuration Server.