HP Color LaserJet Enterprise M855 and Flow MFP M880 - Hole Punch Kit Installation Guide
6
29
27
30
28
31
$:
&=
ZZZKSFRPVXSSRUWFRORUOM0
ZZZKSFRPVXSSRUWFRORUOMƮRZ0)30
/HDHVWRSULPHUR
Slightly lift up on the punch hole assembly (callout 1), and then
disengage the sheet-metal support bracket (callout 2).
NOTE: The punch hole assembly is still fastened to the accessory
chassis, but you should be able to disengage the support bracket.
Remove one screw.
Remove one screw. Lift the assembly up to release it, and then remove the assembly.
Responsibly dispose of the failed assembly.
Unpack the replacement assembly. If present, remove all packing
materials.
Installation is the reverse of removal.
NOTE: See the special installation instructions section on the
following pages after installing the replacement assembly.