HP LaserJet Enterprise M806, M830, M855, M880 - PJL commands used for stapling or hole punching (white paper)

The “NONE” option in the first PROCESSINGOPTION command (stapling) is needed to make sure to
override the default stapling setting in the control panel.
Stapling and Hole Punching
To Staple and Hole Punching the following PJL commands need to be sent:
@PJL SET PROCESSINGACTION=APPEND
@PJL SET PROCESSINGTYPE="STAPLING"
@PJL SET PROCESSINGOPTION="<stapling_option>"
@PJL SET PROCESSINGBOUNDARY=MOPY
@PJL SET PROCESSINGTYPE="PUNCH"
@PJL SET PROCESSINGOPTION="<punch_option>"
@PJL SET PROCESSINGBOUNDARY=MOPY
Only certain Stapling and Hole Punching combinations are supported (and possible). To perform the
Stapling and Hole Punching action, in the following tables find the combination that wants to be
performed and only use the combinations of “stapling_option” (first PROCESSINGOPTION command for
stapling) and “punch_option” (second PROCESSINGOPTION command for punch) that are in the same
row.
US format (two or three holes)
Description
stapling_option
punch_option
One Staple in the Top left corner with Two Holes (always
staple in the top left and punch along the top side or along
the left side)
ONE_STAPLE
2HOLE or 2PT_US
One Staple in the Top Left corner with Two Holes along the
Left side (if not possible, no stapling + punching is done)
LEFT_1PT or
LEFT_1PT_ANGLED
LEFT_2PT_US
One Staple in the Top Right corner with Two Holes along the
Right side (if not possible, no stapling + punching is done)
RIGHT_1PT or
RIGHT_1PT_ANGLED
RIGHT_2PT_US
One Staple in the Top Left corner with Two Holes along the
Top side (if not possible, no stapling + punching is done)
LEFT_1PT or
LEFT_1PT_ANGLED
TOP_2PT_US
One Staple in the Top Right corner with Two Holes along the
Top side (if not possible, no stapling + punching is done)
RIGHT_1PT or
RIGHT_1PT_ANGLED
TOP_2PT_US
One Staple in the Top left corner with Three Holes (always
staple in the top left and punch along the top side or along
the left side)
ONE_STAPLE
3HOLE or 3PT_US
One Staple in the Top Left corner with Three Holes along the
Left side (if not possible, no stapling + punching is done)
LEFT_1PT or
LEFT_1PT_ANGLED
LEFT_3PT_US
One Staple in the Top Right corner with Three Holes along
the Right side (if not possible, no stapling + punching is done)
RIGHT_1PT or
RIGHT_1PT_ANGLED
RIGHT_3PT_US
One Staple in the Top Left corner with Three Holes along the
Top side (if not possible, no stapling + punching is done)
LEFT_1PT or
LEFT_1PT_ANGLED
TOP_3PT_US
One Staple in the Top Right corner with Three Holes along
the Top side (if not possible, no stapling + punching is done)
RIGHT_1PT or
RIGHT_1PT_ANGLED
TOP_3PT_US