Installation Manual

Hayes 2400 Smartmodem
At the router end:
Configure with a terminal or PC using the following sequence:
at&f&c1&d2&s1
ats0=1
Depress the ANS button. The red light should go ON.
At the user end:
Configure with a terminal or PC using the following sequence:
at&f&c1&d2&s1
Black Box V.32 9600 Async.
At the router end: Load the factory option set #1. Then change the
following submenus:
Data Rate Menu: change to 9600 uncoded
Modem Parameters Menu: change to Forced Answer
DTE Parameters Menu:
Set DTR State to Responds to DTR Change
Set DSR State to DSR is Normal
Set CTS State to CTS is Normal
Set DCD State to DCD is Normal
At the user end: Configure as at the router end, except:
Modem Parameters Menu: change to Normal Originate
Modem
Configuration
B
Modem Configuration
B-3