User's Manual

Operating Notes
Parameter List
Quick Configuration is set to the following default parameter values at
the factory and whenever you use the Reset/Clear button combination to
clear the router. (For more on clearing the router, refer to the
installation guide.)
Parameter Default
System name
IP host-only
SNMP enabled
TELNET enabled
Brg Enab
DoD IP Address
DoD IP Subnet Mask
IPX Network
Port Conf
Ring interface (token ring)
Link type (WAN)
Bridge type (FDDI)
WAN Port Parameters
Quality of service (WAN)
Point-to-Point address
(WAN)
AppleTalk Net Range
AppleTalk Zone Name
DECnet area.node
DEFAULT_CONFIG
NO (leaves router in router/host mode)
NO
NO
YES (enables bridging on indicated port)
—
—
— (IPX network number)
16
HP (Hewlett-Packard)
TR (Translating)
AUTO
AUTO
—
—
—
Note that when you start the Quick Configuration utility, the cursor is
always set to the ‘‘System name’’ field. (The default system name is
DEFAULT_CONFIG.) Also, the Help messages are active unless you
have previously used the / 5 hotkey combination to turn them off.
Quick
Configuration
3
How To Use Quick Configuration
Operating Notes
3-27