User's Manual
MenuandToolbarOptions
3Com®AirProtectPlannerUserGuide
53
Figure 63. Changing Location Properties – Dimensions Tab
Specifythefollowingdimensionsandproperties:
• Unit:Selecttheunitofmeasurementfromthedrop‐downlist.
• Lengthin‘a’direction:Specifythelengthtobeusedforalllayoutsintheplan.
• Lengthin‘b’direction:Specifythewidthtobeusedforalllayoutsinthe
plan.
• LockAspectRatio:SelecttheLockAspectRatiocheckbox,ifyouwanttomaintaintheratioofthedimensionsofthe
layouttothatofthelayoutimage.
• RFCalculationCellSize:SpecifytheRFcalculationcellsizetodeterminethesizeofthesmallestuniton
thelayout.
Plannerperformscalculationsforeachcellonthelayout.
• ResetCellSize:Clicktogetoptimalcellsizenumberforthelayoutdimensionsentered.
• CeilingLoss:Specifythelossoccurringforthecrossfloorradiationduetotheceiling.Therangeis‐50to0.
• Region:
Selecttheregionfromthedrop‐downlist.
Note:Changingthelengthandwidthoftheplanresizestheentiresetofobjectsinthelayoutmodel.Plannerresizestheobjectsinthesame
proportioninwhichthesizeoftheplanischanged.Changingtheseunitswillaffectthedimensionvaluesandcoverage.
Duringresize,ifthereareanyobjectslikePolygonsorAreaPolygonsplacedonthefloormap,Plannerdeletestheseobjects,asitcannot
resizethem.
Thesechangesaffectallthe
layoutsintheplan.Incaseyouwanttoplanmultiplefloorswithdifferentdimensions,enterthelargestfloor
dimensionsandthenplanforsmallerareasforeachfloor.
LocationProperties:CalculationsTab
TheCalculationstaballowsyoucanspecifythecalculations’settingsandpathlossmodelsettings.Youcanalsoinvokethis
screenbyclicking
fromtheToolbar.