Technical data

5-8 FRU Removal and Replacement
5.3.3 Network Interface Board Removal and Replacement (Model 400t and 400dl)
Figure 5-6 shows how to remove the network interface board. First remove the graph
-
ics board. Then remove the screw from the network board’s connector plate. To remove
the network board, push the board from the connector side to disengage the board
from the CPU board connector. Refer to Appendix A to verify that the replacement
board is jumpered correctly. To replace the board, reverse the removal procedure. Be
sure that the board’s connector plate is seated properly in the chassis.
Figure 5-6. Network Interface Board Removal (Model 400t and 400dl)