Technical data

5-36 FRU Removal and Replacement

5.5.9 Mass Storage Device Removal and Replacement (Model 400s)

Refer to Figure 5-28 and Figure 5-29 and follow these steps to remove a mass storage

device.

1. Remove the top cover, both side covers, and the right trim plate.

2. Remove the screw in each mass storage access cover. Remove the cover from

the left side of the chassis.

3. Remove the two screws on the right front edge of the chassis holding the de-

vice bracket to the chassis.

4. Slide the device out about two inches. Be careful not to loosen any of the RFI

clips attached to the chassis or device.

5. Disconnect the SCSI and power cable connectors from the back of the device.

6. Remove the bracket holding the device by sliding it out of the front of the unit.

7. Remove the screws holding the device in its mounting bracket and remove the

device. These screws are different from the other screws in the system unit;

keep them separate.

• For full-height devices, one screw attaches the device to the bracket on

each side.

• For half-height devices, there are two or four screws in the bracket holding

the device. Remove these screws and pull the device out of the front of the

bracket.

8. Note the conﬁguration jumper locations in Appendix B for setting the device

address and other functions.

Reverse these steps to replace a mass storage device.