Technical data

Confi guring the EEPROM C-1
Appendix C
Configuring the EEPROM for HP-UX Systems
This appendix explains how to use Configuration Control Mode to configure the EE-
PROM.
C.1 Workstation Configurations
Your workstation may be configured with one of several combinations of system con-
sole, type of operating system, and internal interface settings. If these configurations
are matched, the correct displays appear and the requested operating system can be
booted. If there is a mismatch, you have to enter Configuration Control Mode and
change the EEPROM configuration. Table C-1 lists typical matched configurations.
Table C-2 lists typical mismatched configurations and what to do to enable the system
console and boot the requested operating system.
Table C-1. System Unit, System Console, and Operating System
Matched Situations at Power-Up
System
Console
RS-232
Mode
Boot
Mode
Op.
System
Display
Shown
What To Do
Monitor
&Kbd.
Monitor
&Kbd.
Local
Remote
HP-UX
HP-UX
HP-UX
HP-UX
Power
Up
Power
Up
Configure internal I/O, if needed.
Configure internal I/O, if needed.