Technical data

C-4 Confi guring the EEPROM
If the select code is not a 9, the then an accessory DIO-II RS-232 interface has
been set to Remote. You must remove the RS-232 accessory card and change
its configuration switches to make a permanent change to the accessory card.
Refer to the interface card’s documentation. Then, power up the system unit.
The system unit resets and the Configure Mode Main menu should appear in
the display’s upper right-hand corner. Go on to the “Using Configuration
Control Mode” later in this appendix to continue configuring your system unit.
C.2.2 Terminal as System Console
When your workstation uses a terminal as the system console and has no pre-installed
operating systems, one of the following situations happen at the first power-up:
• The following Configuration Mode Main menu appears on the right-hand side.
You may continue configuring your system unit by referring to the “Using Con-
figuration Control Mode” later in this appendix.
Configuration Control
Keys Control Class
-----------------------------
1 I/O Configuration
2 Boot Mode Selection
A Abort without changes
-----------------------------
Type [key] RETURN ?
• If nothing appears on the display, the system unit’s internal RS-232 interface
has been set to Local mode. You must reconfigure your system unit’s RS-232
interface to Remote mode. The next section explains how to do this.