Technical data

Conﬁ guring the EEPROM C-5

Reconﬁguring the RS-232 Interface to Remote Mode

Follow these steps (refer to Figure C-1) to temporarily reconﬁgure your system unit’s

RS-232 interface to Remote mode when you power-up the system unit and no display

appears on your terminal:

1. Set Service/Normal switch to Service.

Figure C-1. System Unit Service/Normal Switch and Reset Button

2. Press the RESET button to reset the system unit.

3. To temporarily change the internal RS-232 interface to Remote so that the ter-

minal may be used as the system console, listen for two beeps (about 5 seconds

after the message appears). Then, type the following command:

R < Return >

The system unit resets and the Conﬁguration Control Main menu appears in the termi

nal display’s right-hand side. Go to the “Using Conﬁguration Control Mode” section

later in this appendix to continue conﬁguring your system unit.