Technical data

C-6 Confi guring the EEPROM
C.2.3 Terminal as System Console with Monitor
If your workstation uses a terminal as the system console and also has a monitor con
-
nected to the video board (but no keyboard connected to the HP-HIL connector), one
of the following two situations happen:
• The following Configuration Control Main menu appears on the right-hand
side. You may continue configuring your system unit by referring to the “Using
Configuration Control Mode” section later in this appendix.
Configuration Control
Keys Control Class
-----------------------------
1 I/O Configuration
2 Boot Mode Selection
A Abort without changes
-----------------------------
Type [key] RETURN ?
• This power-up display appears on the monitor. Type the following command
and the system unit resets:
R < Return >
The following Configuration Control Mode Main menu then appears. You may
continue configuring your system unit by referring to the “Using Configuration
Control Mode” section later in this appendix.
Copyright 1990,
Hewlett-Packard Company,
All Rights Reserved.
Series 400 Rev. 1, 5 Jun 90
md 12 rev 0.20, 1990/03/12.16:31:17
Bit-Mapped Video
MC68030 Processor
MC68882 Coprocessor
Configuration EEPROM
HP-HIL.Keyboard
Type R RETURN for internal RS-232 console
HP-IB
DMA-C0
RAM 4194080 Bytes
HP98644 (RS-232) at 9
HP98265 (SCSI S 32) at 14
HP98643 (LAN) at 21, THIN, 080009AAAAAA
HP PARALLEL at 12
Configuration Mode
RESET to Power-up
Configuration Control
Keys Control Class
-----------------------------
1 I/O Configuration
2 Boot Mode Selection
A Abort without changes
-----------------------------
Type [key] Return ?