Technical data

C-14 Confi guring the EEPROM
Table C-4. Configuration Mode Entry Error Messages
Error Message Meaning and What To Do
(No error message)
EEPROM Has Bad Information
EEPROM Load Section Missing
EEPROM Defaults Section Missing
Too much data to save
If Configuration Mode does not start and no error
message appears, a hardware failure probably
occurred. Replace CPU board.
Configuration Mode started and main menu may
appear, but something failed. Try again. Replace
CPU board.
Could not load new configuration data. Hardware
failure. Replace CPU board.
Default configurations could not be found.
Hardware failure. Replace CPU board.
Too many interfaces for EEPROM to manage.
Reconfigure system unit with fewer interfaces.
Only the interfaces’ select codes are listed in the main Configurable Interfaces menu.
HP-IB is fixed at select code 7 and cannot be changed. Most built-in interfaces have
several configurable features. Interface default values are listed in the following table.
Table C-5. Built-in Interface Default Configurations
Interface Configuration Function Default Options
Optional HP-IB
RS-232
SCSI
Thin/AUI LAN
HP Parallel
Select Code (cannot be changed)
System Controller
Select Code
Remote/Local
Sys. Unit Shipped with Keyboard
Sys. Unit Shipped without Keyboard
Interrupt Level
Modem Enable
Select Code
Interrupt Level
Bus Address
Parity
Select Code
Interrupt Level
Select Code
Interrupt Level
7
Yes
9
Local
Remote
3
Yes
14
3
7
Yes
21
5
12
3
None
No
0 to 31
Remote
Local
3 to 6
No
0 to 31
3 to 6
0 to 7
No
0 to 31
3 to 6
0 to 31
3 to 6