Technical data

C-28 Confi guring the EEPROM
C.5.2 Selected System
If you want to boot a specific operating system and more than one exists on your mass
storage devices, set the
Selected System status to yes (Y), then type the E (execute)
command. The system unit resets and the power-up display changes to list mass stor
-
age devices with operating systems mounted on them. The display is similar to the
following:
Copyright 1990, :HP7958, 1405, 0
Hewlett-Packard Company, 1H SYSTEM_HPUX
All Rights Reserved.
Series 400, Rev. 1, 5 Jun 90 :RODIME, 1404, 0
md 12 rev 0.20, 1990/03/12.16:31:17 2H SYSTEM_HPUX
Bit-Mapped Video
MC68030 Processor
MC68882 Coprocessor
Configuration EEPROM
HP-HIL.Keyboard
HP-IB
DMA-C0
RAM 4194080 Bytes
HP98644 (RS-232) at 9
HP98265 (SCSI S 32) at 14
HP98643 (LAN) at 21, THIN, 080009AAAAAA
HP PARALLEL at 12
System Search Mode, will store selection
RESET to Power-up SPACE clears input Select System Type RETURN ?
For example, if you wanted to select the HP-UX operating system on the Rodime Disk
Drive, you would type the following command
2H < Return >
and the HP-UX operating system would then start booting. The HP UX operating sys-
tem would then be stored and automatically booted the next time you turned on the
system unit.