User's Manual

Required End Product Labeling

Any device incorporating this module must include an external, visible, permanent marking

or label which states: “Contains FCC ID: B94-AX200NGWP”

Additional testing, Part 15 Subpart B disclaimer

The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC

transmitter rules) listed on the grant, and that the host product manufacturer is responsible

for compliance to any other FCC rules that apply to the host not covered by the modular

transmitter grant of certification.

The final host product still requires Part 15 Subpart B compliance testing with the modular

transmitter installed.

FCC

This module has been tested and found to comply with the following requirements for

Modular Approval.

 Part 15.247 - Operation within the bands 902-928 MHz, 2400-2483.5 MHz, and

5725-5850 MHz.

 Part 15.407 – General technical requirements.

Test Modes

This device uses various test mode programs for test set up which operate separate from

production firmware. Host integrators should contact the grantee for assistance with test

modes needed for module/host compliance test requirements.

The OEM integrator has to be aware not to provide information to the end user regarding

how to install or remove this RF module in the user’s manual of the end product which

integrates this module. The end user manual shall include all required regulatory

information/warning as shown in User manual.