HP Color LaserJet Pro MFP M277 - Getting Started Guide

Reproduction, adaptation or translation without prior written permission is

prohibited, except as allowed under the copyright laws.

The information contained herein is subject to change without notice.

The only warranties for HP products and services are set forth in the express

warranty statements accompanying such products and services. Nothing herein

should be construed as constituting an additional warranty. HP shall not be liable

for technical or editorial errors or omissions contained herein.

Trademark Credits

Windows® is a U.S. registered trademark of Microsoft Corporation.

Reproduction, adaptation or translation without prior written permission is

prohibited, except as allowed under the copyright laws.

The information contained herein is subject to change without notice.

The only warranties for HP products and services are set forth in the express

warranty statements accompanying such products and services. Nothing herein

should be construed as constituting an additional warranty. HP shall not be liable

for technical or editorial errors or omissions contained herein.

Trademark Credits

Windows® is a U.S. registered trademark of Microsoft Corporation.

FCC Regulations

This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the FCC rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio-frequency

energy. If this equipment is not installed and used in accordance with the

instructions, it may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment o and

on, correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase separation between equipment and receiver.

• Connect equipment to an outlet on a circuit dierent from that to which the

receiver is located.

• Consult your dealer or an experienced radio/TV technician.

Any changes or modications to the product that are not expressly approved by

HP could void the user’s authority to operate this equipment. Use of a shielded

interface cable is required to comply with the Class B limits of Part 15 of FCC rules.

For more regulatory information, see the electronic user guide. HP shall not be

liable for any direct, indirect, incidental, consequential, or other damage alleged

in connection with the furnishing or use of this information.

B3Q10-91017.indd 12 4/14/2016 12:16:17 AM