Brocade EZSwitchSetup Administrator's Guide - Supporting Fabric OS v5.3.0 and Brocade 200E, 3250, 4100, 4900, 5000 (53-1000441-01, June 2007)
EZSwitchSetup Administrator’s Guide 3
53-1000441-01
Requirements, Installation, and Support
1
4. Under “Check for newer versions of stored pages” click Every visit to the page.
FIGURE 2 Configuring Internet Explorer
SWITCH SUPPORT
You can use EZSwitchSetup with the following hardware:
• Brocade 200E switch
• Brocade 3250 switch
• Brocade 4100 switch
• Brocade 4900 switch
• Brocade 5000 switch
Your switch must meet the following requirements:
• Must be reachable through an IP address. If it is not, you get the message “Page not Found.”
• Must be in a single-switch fabric. If your switch connects to another switch (if there is an E_Port
on the switch), you cannot manage the switch using EZSwitchSetup until you disconnect the
switch connection.
• Must be running Fabric OS v5.3.0.
• The client host machine must have the proper browser and Java Plug-in installed. See Table 1
on page 2 for the list of supported browsers.
NOTE
If there is an E_Port on the switch and if there is a zone conflict, then the fabric is segmented;
in this case, the switch is in a fabric by itself and EZSwitchSetup treats it as a single-switch
fabric.
Configure your browser to
check for newer versions of
stored pages every visit to the
page.