Brocade EZSwitchSetup Administrator's Guide - Supporting Fabric OS v5.3.0 and Brocade 200E, 3250, 4100, 4900, 5000 (53-1000441-01, June 2007)

10 EZSwitchSetup Administrator’s Guide
53-1000441-01
Set Up the Switch IP Address
2
2. To set up IPv6 addresses
a. Enter the IPv4 address and click Configure IPv6.
b. Enter the IPv6 address and CIDR block.
c. Click OK.
d. Click Next.
NOTE
IPv6 is not supported in RedHat Linux9 OS.
FIGURE 7 IPv6 dialog
EZSwitchSetup verifies that the switch is accessible over the ethernet connection and that no
other switch has the same IP address. The switch returns its unique World Wide Name (WWN).
If the setup is successful, a confirmation screen is displayed (shown in Figure 8).
You can remove the serial cable from the switch, as long as you do not need to go back and
revise any of the information you entered. You should set it aside in case you lose network
connectivity.
FIGURE 8 EZSwitchSetup Confirmation Step