Brocade EZSwitchSetup Administrator's Guide - Supporting Fabric OS v5.3.0 and Brocade 200E, 3250, 4100, 4900, 5000 (53-1000441-01, June 2007)

EZSwitchSetup Administrator’s Guide 17
53-1000441-01
Connect Devices and Complete the Setup
2
Connect Devices and Complete the Setup
The final step in the Switch Configuration wizard is to connect the devices to your switch according
to the Typical Zoning scheme. The Connect Devices screen (see Figure 14) displays a graphical
representation of the switch with the defined device connections. The Connect Devices screen
provides feedback as you cable the switch. A green line indicates that the connection is correct, a
red line indicates an invalid connection, and a blue line indicates a missing connection. You can
view details of the device by hovering your mouse over the host or storage icon.
FIGURE 14 Connect Devices Screen
To connect devices and complete the setup
1. Install the small form factor pluggable (SFP) transceivers in the Fibre Channel ports shown
onscreen. (See Figure 15 on page 18).
a. Remove any protector plugs from the SFP transceivers to be used.
b. Position and insert each SFP transceiver as required (right side up in the top row of ports
and upside down in the bottom row of ports) until it is firmly seated.