HP StorageWorks Fabric OS 6.1.1 administrator guide (5697-0235, December 2009)

Fabric OS 6.1.x administrator guide 281
4. Issue the cfgEnable command.
switch:admin> cfgenable iscsi_cfg001
You are about to enable a new zoning configuration.
This action will replace the old zoning configuration with the
current configuration selected.
Do you want to enable 'iscsi_cfg001' configuration (yes, y, no, n): [no] y
zone config "iscsi_cfg001" is in effect
Updating flash ...
switch:admin>
iSNS client service configuration
The internet storage name service (iSNS) server facilitates the automatic discovery and manages access
control of iSCSI VTs on a TCP/IP network.
iSNS clients initiate transactions with iSNS servers using the iSNS protocol, register available iSCSI VTs,
download information about other registered clients (such as iSCSI initiators), and receive notification of
events that occur in the DDs.
Figure 26 iSCSI network with iSNS server and clients
NOTE: Fabric OS supports only Microsoft iSNS Server 3.0 and later.
Displaying iSNS client service status
1. Connect and log in to the switch.
2. Issue the fosConfig command to show the current Fabric OS configuration.
switch:admin> fosconfig --show
FC Routing service:disabled
iSCSI service:enabled
iSNS Client service:disabled
iS NS client
FC
target 1
iS NS
server
iS CS I
VT 1
iS CS I initiator
iS CS I gateway s ervice
iS NS client
IP Network
FC SAN