HP StorageWorks Fabric OS 6.1.1 administrator guide (5697-0235, December 2009)

Fabric OS 6.1.x administrator guide 421
556200 Bps 30s avg, 491394 Bps lifetime avg
Table 91 Command checklist for configuring FCIP links
Step Command
1. Configure IPSec policies (optional). policy - -create
2. Persistently disable ports. portcfgpersistentdisable
3. If a VEX port is to be implemented,
configure the appropriate virtual port as
a VEX_Port.
portcfgvexport
4. Configure the IP interface for both
ports of a tunnel.
portcfg ipif
5. Verify the IP interface for both ports
of a tunnel.
portshow ipif
6.Create one or more IP routes
connecting the IP interfaces across the IP
network.
portcfg iproute
7. Create ARP entry for the IP interface if
VLAN tagging is to be implemented.
(For IPv4 only, not required for IPv6).
portcfg arp add
8.Test IP connectivity between the local
Ethernet interface (ge0 or ge1) and a
destination IP address.
portcmd - -ping
9. Configure FCIP tunnels. portcfg fciptunnel
10. If you are implementing FICON
emulation, configure FICON emulation.
portcfg ficon
11. If you are implementing FTRACE,
configure FTRACE.
portcfg ftrace
12. Verify FCIP tunnels. portshow fciptunnel
13. Enable the ports. portpersistentenable