Instruction Manual

Modifications
The FCC requ ires the
user to be notifi ed that any changes or modifications made to
this device that are not expressly approved by Hewlett-Packard Company my void the
user’s authority to operate the equipment.
Cables
Connections to this device must be made with shielded cables with metallic RFI/EMI
connector hoods i n ord er to maintain compliance with FCC Rules and Regulations.
Re gulatory compliance identification numbers
For the purpose of regulatory compliance certifications and identification, your product
has been assigned a unique Regulatory Model Number. The RMN can be found on the
product nameplate label, along with all required approval markings and information.
When requesting compliance information for this product, always refer to this RMN. The
Regulatory Model Numb er should not be confused with the marketing nam e or model
number of the product.
The Regulato
ry Model Number for the Brocade 4Gb SAN Switch is:
HSTNS-1B10
Laser device
All HP systems equipped with a laser device comply with safety standards, includ ing
International Electrote chnical Commission (IEC) 825. With specificregardtothelaser,
the equipment complies with laser product performance standards set by government
agencies as a Class 1 laser product. The product does not emit hazardous light.
Laser safety warning
WARNING!
To reduce the risk of exposure to h azardous radiation:
• Do not try
to open the laser devi ce enclosure. There are no user-serviceable
components inside.
• Do not operate controls, make adjustments, or perform procedures to the laser
device o
ther than those specified herein.
• Allow only HP authorize d service technicians to repair the laser device.
56
Regulatory compliance and safety